PYLE Audio PSL32X - Manual

- 4 -
INSTRUCTION MANUAL
www.pyleaudio.com
02'(/ 36/;;;;
5(*8/$7(''&
32:(5 6833/<
OPERATION:
1 INSERT AC POWER PLUG INTO A 110V VOLT AC OUTLET.
2 CONNECT THE POWER CORD OF YOUR EQUIPMENT (13.5V-14.1VDC) TO THE
OUTPUT BINDING POST TERMINALS ON THE FRONT OF THE UNIT BE SURE THAT
POLARITY IS CORRECT THE RED POSITIVE (+) TERMINAL AND BLACK NEGATIVE
(-) TERMINAL ARE MARKED. REVERSAL OF POLARITY MAY DAMAGE YOUR
EQUIPMENT.
3 TURN SWITCH TO “ON”, RED LIGHT IN SWITCH WILL ILLUMINATE.
4 THE INPUT POWER IS PROTECTED BY THE FUSE WHICH IS LOCATED AT THE REAR
OF THE UNIT AND CAN BE REPLACED BY UNSCREWING THE FUSE HOLDER IF
THE FUSE IS BURNT OUT. DO NOT USE A FUSE LARGER THAN … AMPS USE OF
HEAVIER FUSE MAY RESULT IN DAMAGING TO THIS UNIT (… SEE NOTE)
5 THIS UNIT HAS ELECTRONIC OVERLOAD PROTECTION WITH INSTANT AUTOMATIC
RESET FUNCTION. IF OUTPUT IS OVERLOADED. THE OUTPUT POWER WILL
AUTOMATICALLY SHUT OFF. RELEASE POWER CORD OF YOUR EQUIPMENT
FROM THE OUTPUT TERMINALS AND CHECK THE ACTUAL POWER RATING OF
YOUR EQUIPMENT THIS UNIT WILL AUTOMATICALLY RESET INSTANTLY.
6 OVER TEMPERATURE PROTECTION CIRCUITRY IS USED IN PSL32X/42X/
72X/82X TO PREVENT OVER HEAT DAMAGE UNIT WILL BE SHUT DOWN
MINUTES AFTER 15 MINUTES( MIN. ) AT 100% RATED LOAD.
25 MINUTES( MIN. ) AT 80% RATED LOAD.
… NOTE PSL32X: 1.5 AMP
PSL42X: 1.0
AMP
PSL72X : 1.5 AMP
PSL82X: 1.5
AMP
CAUTIONS:
1. DO NOT USE WITH EQUIPMENT REQUIRING MORE THAN RATING AMPS
2. DO NOT USE OUTDOORS DO NOT EXPOSE UNIT TO RAIN, MOISTURE, WATER OR
ANY OTHER LIQUIDS.
3. DO NOT REMOVE COVER IN ANY CASE. RETURN TO DEALER FOR REPAIR IF
DAMAGED.
4. THIS UNIT HAS A SPECIAL BUILT-IN FEATURE THAT WILL SHUT THE UNIT DOWN
IF MARKED AMPERAGE IS EXCEEDED. THIS WILL AVOID BURN-OUT OF YOUR
EQUIPMENT AND OF UNIT. IF UNIT DOES CONSISTENTLY SHUTDOWN. THIS
MEANS YOU ARE DRAWING TOO MUCH AMPERAGE RETURN UNIT TO PLACE
OF PURCHASE AND UPGRADE TO NEXT AVAILABLE UNIT OFFERING HIGHER
AMPERAGE. PLEASE DO NOT BYPASS OR ALTER THIS CIRCUIT AS IT IS THERE TO
PROTECT YOU. ANY ALTERATION OR MISUSE WILL VOID YOUR WARRANTY.
“DANGER”
HIGH VOLTAGE
REFER TO QUALIFIED TECHNICIAN FOR SERVICE.