Pioneer VSX-D914 - Manual (Page 15)

Quick surround sound setup 03
15
En
If you see an ERR message in the display,
there may be a problem with your mic or the
speaker connections.
Turn off the power, and check the problem
indicated by the
ERR message (see below),
then try the auto surround setup again.
• ERR MIC – Check the microphone
connection.
• ERR Fch – Check the front speaker
connections.
• ERR Sch – Check the surround or
surround back speaker connections.
• ERR SW – Make sure the subwoofer has
been switched on and volume on the
subwoofer is turned up.
7 Use and to select the speaker
system that corresponds to your setup.
Cycle between the following choices:
* Indicates a subwoofer is included in your
speaker setup
See the table on page 12 if you’re unsure
which speaker system to select.
8 If you selected a speaker system that
includes a subwoofer, press ENTER to
check the subwoofer output level.
If the subwoofer output level is too high/low,
SW.VOL.DWN / SW.VOL.UP blinks in the
display for five seconds. To exit and check
your subwoofer output level, press
MCACC
SETUP (see the notes regarding noise levels
below) or simply press ENTER when you’re
prompted to GO NEXT?
9 Press ENTER to finish the auto
surround setup.
The system checks for speaker size, channel
delay and channel level. If you have
connected a subwoofer, it will check for
ambient noise once again.
When the auto surround setup is complete,
the volume level returns to normal and
COMPLETE , then RESUME shows in the
display. The MCACC indicator then lights to
show that MCACC setup is complete.
• If the room environment is not optimal for
the auto surround setup (too much
ambient noise, echo off the walls, obsta-
cles blocking the speakers from the
microphone) the final settings may be
incorrect. Check for household appli-
ances (air conditioner, fridge, fan, etc.),
that may be affecting the environment
and switch them off if necessary.
• Some older TVs may interfere with the
operation of the mic. If this seems to be
happening, switch off the TV when doing
the auto surround setup.
• Using the MCACC system to set up your
speaker system overwrites any previous
settings you had for the
STANDARD or
ADVANCED SURROUND modes.
• When the STANDARD or ADVANCED
SURROUND mode is selected, you can
check the settings made with MCACC by
using
CH SELECT (to check channel
levels) or by going through the steps in
Choosing your receiver setup on page 42
to check other settings.
• Depending on the characteristics of your
room, sometimes identical speakers with
cone sizes of around 5 inches (12cm) will
end up with different size settings. You
can correct the setting manually using
the receiver setup on page 42.
7.1ch*
7.0ch
4.0ch
4.1ch*
2.0ch 2.1ch* 3.1ch* 3.0ch
6.1ch* 6.0ch 5.0ch 5.1ch*
VSX_D912.book.fm 15 ページ ２００３年１２月５日 金曜日 午前９時４３分