Additional information 11, Resetting the main unit, Switching the speaker impedance – Pioneer VSX-D914 User Manual

Page 67

Advertising
background image

Additional information

11

67

En

• If the unit does not operate normally due to external effects such as static electricity discon-

nect the power plug from the outlet and insert again to return to normal operating condi-
tions.

Resetting the main unit

Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.

1

Switch the receiver on.

2

While holding down the TONE button,

press and hold the

STANDBY/ON

button for about three seconds.

3

When you see RESET? appear in the

display, press the TONE button.
OK?

shows in the display.

4

Press TONE once more to confirm.

OK

appears in the display to indicate that the

receiver has been reset to the factory default
settings.

Switching the speaker
impedance

We recommend using speakers of 8

with

this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6

impedance rating.

With the receiver in standby, press

STANDBY/ON while holding down the
SPEAKERS button.

Each time you do this, you switch between the
impedance settings:

SP 6 OHM

– Use this setting if your

speakers are rated at 6

.

SP 8 OHM

– Use this setting if your

speakers are rated at 8

or more.

Can’t operate the remote
control.

• Replace the batteries (refer to page 6).
• Operate within 23 feet ( 7 m), 30° of the remote sensor on the front
panel (refer to page 7).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.

The display is dark or off.

• Press

FL DIMMER

on the remote control repeatedly to return to

the default.

Problem

Remedy

VSX_D912.book.fm 67 ページ 2003年12月5日 金曜日 午前9時43分

Advertising
This manual is related to the following products: