Philips BDP3020/F8 - Manual (Page 7)

7 EN
EN
FUNCTIONAL OVERVIEW
* The unit can also be turned on by pressing these buttons.
1. Disc tray
• Place a disc when opening the disc tray.
2. A (open/close) button*
• Press to open or close the disc tray.
3. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
4. Display
• Refer to “Front Panel Display” on page 10.
5. C (stop) button
• Press to stop playback.
6. B (play) button*
• Press to start or resume playback.
7.
Q (standby-on) button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
• This button lights up in red when the unit is in
standby mode and turns off when the power is on.
8. SD card slot
• Insert an SD Memory Card and play back the
contents in it.
1. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
2. LAN terminal
• Use to connect a telecommunications equipment
with LAN cable.
3. HDMI OUT jack
• Use to connect to a display with an HDMI compatible
port with an HDMI cable.
4. AUDIO OUT jacks
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA audio cable.
5. COMPONENT VIDEO OUT jacks
• Use to connect a TV monitor with component video
inputs with an RCA component video cable.
6. DIGITAL OUT (COAXIAL) jack
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio coaxial input jack with a digital audio coaxial
cable.
7. VIDEO OUT jack
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA video cable.
Front Panel
1 2* 4 5 6* 7 3 8
Rear Panel
LAN
HDMI OUT
L Y P R /C R
P B /C B
R COAXIAL
COMPONENT
VIDEO OUT
AUDIO
OUT
VIDEO
OUT
DIGITAL OUT
PCM/BITSTREAM
3 2 5
6
1 4
7
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
In
tr
od
uct
ion
Con
n
ec
ti
o
n
s
B
as
ic Setup
P
layb
ack
Others
Fu
nc
ti
on
Set
u
p