Recharging the built-in battery, Setting the time code, Specifying the time code (tc preset) – Panasonic AG-HVX200 User Manual

Page 60

Advertising
background image

60

Recharging the built-in battery

The camera’s internal battery saves the date and
time. “

” appears on the screen of the viewfinder

or LCD when the internal battery is running low on
charge.
Do the following to recharge it.
Reset the date and time when fully recharged.

1

Connect the AC adapter. (Page 17)

• Leave the POWER switch at OFF.

2

Leave the camera-recorder like this for

about 4 hours.
• The internal battery charges during this time.
• Recharge the battery regularly to ensure

correct TC and menu operations.

If “

” appears even after charging, it means that

the internal battery must be replaced. Ask your
dealer to do this.

Setting the time code

In the setup menus, RECORDING SETUP screen,
set the following time code related items. (Page
108)
• TC MODE
• TCG
• FIRST REC TC
(Tape only)
• TC PRESET
• 1394 TC REGEN
(appears when in MCR/VCR

mode)

In MCR/VCR mode and 1394 TC REGEN is ON,
you cannot change the items shown above.

Charging the built-in battery/Setting the time data

Specifying the time code

(TC PRESET)

Set TC PRESET so you can record a value of your
choice as the initial setting for the time code to be
used at the start of recording.

1

Set the POWER switch to ON.

2

(Tape only) In the setup menus,

RECORDING SETUP screen FIRST REC TC,
select PRESET.
• For menu operation (Page 97)
• You can also use the menu buttons on the

remote control. (Page 15)

3

Press the and buttons to select TC

PRESET, and press the button.

4

Press the button to select YES, and press

the button.

Advertising