Panasonic AG-HVX200 - Manual (Page 91)

Displa
ys
91
Regular displays
Screen displays
1 Time code displays
Each time you press the COUNTER button, the
display switches over to the following data (or
no indication).
COUNTER: (Tape or P2-camera mode only)
Counter value
M COUNTER: (Tape only)
Counter value in memory stop mode
TC:
Time code value. When the time code value
could not be read correctly from the P2 card
or the tape, [TC
∗
] is displayed.
When it acts in drop frame mode, the colon
between seconds and frames become “.”.
tc: (P2 card only)
Time code value. (During FILM CAM mode,
the frame digits are displayed in 24 frames)
When the time code value could not be read
correctly from the P2 card, [tc
∗
] is displayed.
When it acts in drop frame mode, the colon
between seconds and frames become “.”.
UB:
User information
When user information could not be read
correctly from the P2 card or the tape, [UB
∗
]
is displayed.
FR:
Frame rate information for recording
FR 60I : Standard (60i interlace) mode (60
fields/sec.)
FR 60P : 60P progressive mode (60 frames/
sec.)
FR 30P : 30P progressive mode (30 frames/
sec.)
FR 24P : 24P progressive mode (24 frames/
sec.)
FR 24PA : 24P advanced mode
When in FR24P and FR 24PA mode, the
sequence information of the frame conversion
at the final place.
2 Warnings
REMOTE:
Blinks when the wrong equipment setting is
selected on the remote control unit.
:
Lights when condensation has formed inside
the camera-recorder.
:
Blinks when cylinder heads are dirty.
P2
or :
Blinks when a P2 card or tape has not been
inserted, or when the camera is in a write-
protected state.
P2
FULL or END:
Blinks when either there is no remaining
capacity in the P2 card or the tape has
reached the end.
P2
LACK:
Blinks in the loop rec mode when the
remaining capacity of the P2 card is
insufficient.
:
Lights when the internal battery for the
calendar has run out. (Page 60)
For details on the safety zone, refer to 36.
(Continued on the next page)