System configuration example, Example of connection to audio-visual equipment – Panasonic PT-L759VU User Manual

Page 41

Advertising
background image

41

System Configuration Example

Notes on system configuration

• Turn off the power supply of each system component before connecting any of the components.
• Read the instruction manual for each system component before connecting it.
• If the necessary cables for connecting any system components are not supplied with the component or available

as an option, you may need to fashion a cable to suit the component concerned.

• If there is a lot of jitter in the video signal input from the video source, the picture on the screen may flicker. In

such cases, it will be necessary to connect a TBC (time base corrector).

• The Projector can be connected to video signal sources which out put VIDEO, S-VIDEO, analog RGB signals,

DVI-D signals [PT-L759XU] and Component signals (YP

B

P

R

signals).

• The Projector has built-in speaker. However, you will need to connect a separate audio system to the

AUDIO OUT terminal if your needs specify high sound volumes.

• It may not be possible to connect some types of personal

computer.

Example of connection to audio-visual equipment

Diagram numbers correspond with numbers (see page

44

.)

• Only one audio signal input system is available for the VIDEO AUDIO IN terminals for S-VIDEO/VIDEO signals, so if

you wish to change the audio input source, you will need to remove and insert the appropriate plugs.

• If an audio system is connected to the AUDIO OUT terminal, muting can be controlled by the remote control which is

supplied with the Projector.

• If the video signal source is connected using a cable with a BNC junction plug, use the BNC-RCA Adaptor (not

included) to convert the pin jack.

VCR

S-Video Cable
(not included)

DVD player

Audio system

5 (Audio Cable)

5 (Audio Cable)

Connector jacks on left side of Projector

5 (Audio Cable)

6 (Video Cable)

Note

Advertising