Panasonic KX-FLM671 - Manual (Page 3)

Important Information
3 For assistance, please visit http://www.panasonic.com/help
Important Information 1For assistance, please visit http://www.panasonic.com/help Important Information
For your safety
Laser radiation
LED light
Fuser unit
Note:
L During or immediately after printing, the area near
the recording paper exit (
2) also gets warm. This is
normal.
For best performance
Toner cartridge and drum unit
L When replacing the toner cartridge or drum unit, do
not allow dust, water, or liquids to come in contact
with the drum. This may affect print quality.
L For optimal performance, genuine Panasonic toner
cartridges and drum units are recommended. We
cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
unit:
–
Damage to the unit
– Poor print quality
– Improper operation
Toner cartridge
L Do not leave the toner cartridge out of the protective
bag for a long time. It will decrease the toner life.
Drum unit
L Read the instructions on page 10 before you begin
installation of the drum unit. After you have read
them, open the drum unit protective bag. The drum
unit contains a photosensitive drum. Exposing it to
light may damage the drum. Once you have opened
the protective bag:
–
Do not expose the drum unit to light for more than
5 minutes.
– Do not touch or scratch the green drum surface.
– Do not place the drum unit near dust or dirt, or in
a high humidity area.
– Do not expose the drum unit to direct sunlight.
L To extend the life of the drum unit, the unit should
never be turned OFF immediately after printing.
Leave the power turned ON for a minimum of 30
minutes after printing.
Location
L To avoid malfunction, do not position the unit near
appliances such as TVs or speakers which generate
an intense magnetic field.
Static electricity
L To prevent static electricity damage to the interface
connectors or other electrical components inside the
unit, touch a grounded metal surface before touching
the components.
Environment
L Keep the unit away from electrical noise generating
devices, such as fluorescent lamps and motors.
L The unit should be kept free from dust, high
temperature and vibration.
L The unit should not be exposed to direct sunlight.
L Do not place heavy objects on top of the unit. When
you leave the unit unused for a long period of time,
unplug this unit from the power outlet.
L The unit should be kept away from heat sources such
as heaters, kitchen stoves, etc. Damp basements
should also be avoided.
The printer of this unit utilizes a laser. Use of
controls or adjustments or performance of
procedures other than those specified
herein may result in hazardous radiation
exposure.
CLASS 1 LED PRODUCT
When using the unit, do not look directly at
the CIS’s LED light. Direct eye exposure can
cause eye damage.
CIS’s LED light properties
LED radiation output : Max. 1 mW
Wavelength : Green 515 nm typical
Emission duration : Continuous
The fuser unit (
1) gets hot. Do not touch it.
1
2