Diagnostic commands, C-23, Table c-12, diagnostic commands – Paradyne 9788 User Manual

Page 287

Advertising
background image

C. Router CLI Commands, Codes, and Designations

9700-A2-GB20-20

December 2002

C-23

Diagnostic Commands

Diagnostic commands allow you to ping or trace the route to a specified
destination.

Table C-12. Diagnostic Commands (1 of 2)

ping

[

protocol] dest-ip [source source-ip] [length bytes]

[timeout

time] [interface intf-type intf-num [.sub-intf-num] ]

Minimum Access Level: Operator
Command Mode: Standard

Pings the specified destination address.

For a successful ping, the results are shown as:

Ping reply [

x.x.x.x]: bytes of data = packet-length

Where

packet-length is the length of echo packets sent.

For a timeout, the results are shown as:

Ping reply [

x.x.x.x]: REQUEST TIMED OUT

For an ICMP echo response of unreachable destination, the results are shown as:

Ping reply [

x.x.x.x]: DESTINATION UNREACHABLE

protocol – The protocol of the IP echo message: ip.

dest-ip – Address of the device to ping.

source – Specify the source IP address.

source-ip – The source IP address used in the ping request. The default source IP
address is the IP address for the interface on which packets are routed to the
destination IP address. The source IP address specified must be an IP address
assigned to an interface or sub-interface.

length

Specify the length of echo packets sent.

bytes – Number of data bytes. Range = 0–1500. Default = 64.

timeout – Specify the time in seconds before the ping test is abandoned.

time – Number in seconds before the ping test is abandoned. Maximum is 30 seconds.
Default = 5 seconds.

interface – Specify the target interface. The default target interface is the interface on
which packets are routed to the destination IP address.

intf-type – Two interface types are supported:

Ethernet – IEEE 802.3 interface

Serial – Frame relay serial interface (SDSL network interface)

intf-num – The interface index number for the Ethernet and the Serial interfaces: 0.

sub-intf-num – The sub-interface number. Sub-interfaces are only supported on the
Network interface (Serial 0). Sub-interface number range is 0–4,294,967,295.

Advertising
This manual is related to the following products: