Troubleshooting, Error code/message – Panasonic CF-51 Series User Manual

Page 19

Advertising
background image

19

Get

ting St

arted

U

seful In

formati

on

Troubleshooting

Appendix

Error Code/Message

Follow the instructions below when an error message or code appears. If the problem persists or if the error code/mes-
sage is not shown here, contact Panasonic Technical Support (

Î page 29).

„ To start the Setup Utility

A Restart the computer.
B Press

F2 several times while [Panasonic] boot screen is displayed soon after the computer begins the startup

procedure.

Error Code/Message

Solution

0211 Keyboard error

z Disconnect external keyboard or mouse.

0251 System CMOS
checksum bad -
Default configuration
used

An error has occurred in the memory of Setup Utility settings. This occurs when the memory
content is changed by an unexpected program operation, etc.
z Start the Setup Utility and return the settings to the default values, and then change the

settings as necessary.

z If the problem persists, the internal clock battery may need to be replaced. Contact

Panasonic Technical Support (

Î page 29).

0271 Check date and
time settings

The date and time settings are not correct.
z Start the Setup Utility and set the correct date and time.
z If the problem persists, the internal clock battery may need to be replaced. Contact

Panasonic Technical Support (

Î page 29).

0280 Previous boot
incomplete - Default
configuration used

Startup has failed repeatedly, so the Setup Utility settings have been returned to the default
values to startup the computer.
z Start the Setup Utility and return the settings to the default values, and then change the

settings as necessary.

Press <F2> to Setup

z Write down the error details and press

F2 to start the Setup Utility. Change the settings if

necessary.

Operating System not
found

The operating system is not installed in the floppy disk or the hard disk that you are going to
boot from.
z If using a floppy disk, change the disk to the one you can use for boot.
z If using the hard disk, check if the hard disk is recognized in [Information] menu of the

Setup Utility. If the hard disk is recognized, perform the reinstallation (

Î page 17). If not,

contact Panasonic Technical Support (

Î page 29).

z If a device is connected to the USB port, disconnect the device, or set [USB Port] or

[Legacy USB Support] to [Disable] in [Advanced] menu of the Setup Utility.

RAM Module Failed

When the RAM module is not inserted correctly or the RAM module is not conforming to the
computer’s specifications, so a beep will sound and the “RAM Module Failed” message will
be displayed when you turn the power on.
z Press the power button for four seconds or longer to turn off the computer, confirm that

the RAM module conforms to the specifications, and reinsert it.

Advertising