Nikon WP-CP2 - Manual (Page 19)

Check for Leaks Again
12
Check for Leaks Again
Before use, be sure that the camera is functioning normally and that the
case does not leak. Failure to check for leaks before use could result in
irreparable damage to the camera.
Important!
After sealing the case, perform a fi nal check for leaks.
Immerse the case in water and check for leaks as
described in Steps 3–6 of “Check the Case for
Leaks” (
6). Check that the desiccant stays dry
and that no water enters the case. If a leak is
detected, immediately remove the case from the
water, dry the camera and case thoroughly, and
check that the O-ring is intact and the case prop-
erly sealed. If the cause of the leak can not be
determined, take the case to a Nikon-authorized
service representative.