Nortel Networks Nortel Backbone Link Node Router 5030 - Manual

TM
1
HotWire 5030 POTS Splitter Customer Premises
Installation Instructions
Document Number 5030-A2-GN10-10
October 1997
Before You Begin
Verify that:
- The local loop POTS service is connected to the POTS/DSL network at the
punchdown block or network interface device (NID).
- New or existing unshielded twisted-pair wiring (CAT3 or better) is used with
this product. The CAT3 wiring must meet EIA/TIA-568 specifications with
24 AWG (.5 mm) or 26 AWG (.4 mm).
For RADSL (Rate Adaptive Digital Subscriber Line) RTU installation information, refer to
the appropriate RTU document:
Document Number Document Title
5216-A2-GN10 HotWire 5216 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
5246-A2-GN10 HotWire 5246 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
5446-A2-GN10 HotWire 5446 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
Package Checklist
Verify that your package contains the following:
-
POTS splitter and housing with closure screw
-
Small plastic bag with two 8–15 x 1
″
Type A combination Phillips/slotted-head
screws and two 1
″
plastic anchors
-
Warranty card
Tools Required
- Flat-blade screwdriver to tighten terminal screws
-
3/8
″
nut driver to close housing securely
-
Phillips-head or combination Phillips/slotted-head screwdriver to mount the housing
-
Drill and 3/16
″
drill bit to mount the housing in cement or cinder block