Appendix, 1) troubleshooting, Indicator messages – Nikon VT695 User Manual

Page 63: ᕡ troubleshooting

Advertising
background image

55

7. Appendix

Indicator Condition

Projector Condition

Note

Off

Blinking light

Steady light

Green

Orange

Green

Orange

0.5 sec On,

0.5 sec Off

2.5 sec On,

0.5 sec Off

0.5 sec On,

0.5 sec Off

The main power is off

The projector is getting ready to turn on.

Off Timer is enabled.

The projector is cooling down.

The projector is turned on.

The projector is in Standby.

Wait for a moment.

Wait for a moment.

Status Indicator

Indicator Condition

Projector Condition

Note

Off

Blinking light

Steady light

Red

Green

Orange

1 cycle (0.5 sec On,

2.5 sec Off)

2 cycle (0.5 sec On,

0.5 sec Off)

4 cycle (0.5 sec On,

0.5 sec Off)

6 cycle (0.5 sec On,

0.5 sec Off)

Normal

Lamp cover error or lamp housing error

Temperature error

Fan error

Lamp error

Re-firing the lamp (The projector is cool-

ing down.)

Cabinet button is locked

Replace the lamp cover or lamp

housing correctly.

The projector is overheated. Move

the projector to a cooler location.

Fans will not work correctly.

Lamp fails to light. Wait a full

minute and then turn on again.

The projector is re-firing.

Wait for a moment.

You have pressed cabinet button

when Cabinet Button is locked.

Lamp Indicator

Indicator Condition

Projector Condition

Note

Off

Blinking light

Steady light

Normal

Lamp has reached its end of life. Lamp

replacement message will be displayed.

Lamp has been used beyond its limit. The

projector will not turn on until the lamp is

replaced.

Lamp mode is set to Eco mode

Red

Red

Green

Replace the lamp.

Replace the lamp.

Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

Power Indicator

Over-Temperature Protection

If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the
lamp with the STATUS indicator blinking (2-cycle On and Off.)
Should this happen, do the following:
• Unplug the power cable after the cooling fans stop.
• Move the projector to a cooler location if the room where you are presenting is particularly too warm.
• Clean the ventilation holes if they are clogged with dust.
• Wait about 60 minutes until the inside of the projector becomes cool enough.

Advertising
This manual is related to the following products: