Nikon LS-2000 - Manual (Page 42)

- 42 - Using the Scanner: Using the SF-200 Slide Feeder
Connecting the SF-200 to the scanner
The scanner must be on its base before the SF-200 can be
inserted. If the scanner is currently installed on its side, turn the
scanner onto its base, with the power switch to the left when
viewed from the front. Slide the SF-200 into the scanner’s
adapter slot, stopping when the feeder contacts the back of the
slot. The SF-200 should be oriented as shown below when
inserted. Push the feeder until the connector on the rear of the
feeder is seated securely in the socket at the back of the slot.
The SF-200 is properly inserted if the status LED on the front of
the feeder lights when the scanner is turned on. If the scanner
is on when the SF-200 is inserted, the feeder’s status LED will
blink once to indicate that the feeder has been inserted cor-
rectly. In all other respects, the feeder LED functions in the
same way as the scanner status LED.
✔
Caution: When the feeder is inserted with the power on, or
the scanner turned on after the feeder has been inserted with the
power off, the feed mechanism will return to the initial position.
While this operation is in progress, the status LED on the front of
the feeder will blink. Do not perform any operations while the LED
is blinking.
Status LED