6 main pcb removal (for high power models) – Nikon RADIUS CM200 User Manual
Radio Disassembly - Detailed
Main PCB Removal (for High Power Models)
Remove the PA screws. See Figure 2-10.
Remove all the screws that fix the PCB to the chassis.
Loosen the M2 screw (about 3 to 4 turns) on the RF connector using hex tool
(Part number: 6680334F39).
Loosening this screw, enables you to unscrew the RF connector from outside.
Carefully remove the main PCB in a diagonal manner.
Figure 2-10 PA Clip and Main PCB Removal (for High Power Models)
It is recommended to grip the volume potentiometer and remove the PCB board