0 radio tuning setup, 1 initial test equipment control settings, Service monitor test set power supply – Nikon RADIUS CM200 User Manual

Page 46

Advertising
background image

4-4

RADIO TUNING AND PROGRAMMING

7.0

Radio Tuning Setup

A personal computer (PC), Windows 95/98/NT and a tuner program are required to tune the radio.
To perform the tuning procedures, the radio must be connected to the PC, radio interface box (RIB),
and test equipment setup as shown in Figure 4-6.

Figure 4-6 Radio Tuning Test Equipment Setup with External RIB

7.1

Initial Test Equipment Control Settings

The initial test equipment control settings are listed in Table 4-2.

Table 4-2 Initial Equipment Control Settings

Service Monitor

Test Set

Power Supply

Monitor Mode: Power Monitor

Speaker set: A

Voltage: 13.8 Vdc (low
power models)
13.6 Vdc (high power
models)

RF Attenuation: -70

Speaker/load:
Speaker

DC on/standby:
Standby

AM, CW, FM: FM

PTT: OFF

Volt Range: 20 V

Oscilloscope Source: Mod
Oscilloscope Horizontal: 10mSec/Div
Oscilloscope Vertical: 2.5 kHz/Div
Oscilloscope Trigger: Auto
Monitor Image: Hi
Monitor BW: Nar
Monitor Squelch: mid CW
Monitor Volume: 1/4 CW

Current: 20A

NOTE

Refer to Tuner on-line help files for tuning procedures.

Wattmeter

Audio Generator

Sinad Meter

AC Voltmeter

30 dB Pad

Audio In

Tx

Rx

Receive

Transmit

RF Generator

RIB

RLN-4008

RLN4460

Test Box

Cable 3080369B72 (9 PIN)

Program/

RKN4083

Test Cable

Service Monitor

or Counter

DB15

Cable 3080369B71 (25 PIN)

Power

Supply

Rx Data

Gnd

Tx Data

Radio

DC

RF

ACC

ELM Adapter

cable FKN8113

Advertising