Nikon LS8000 - Manual (Page 107)

97
Thumbnails are displayed in the thumbnail drawer in the scan window in the order shown
below.
Direction of
insertion
Cautions
Do not place negative and positive film in the holder at the same time.
To avoid damaging the film, use a blower to remove dust and lint from the film and holder.
Leaving dust, lint, or other foreign objects on the film or holder during scanning could result in
reduced image quality or in damage to the film.
Mounts must be 1.0–3.2 mm in thickness. Other mounts can not be used.
Do not use force when inserting slides. Failure to observe this precaution could damage the clips
that hold the mounts in place. Should you encounter resistance, try inserting the slides at a slight
angle.
Be sure to insert slides between the guides. The scanner may not be able to adjust focus correctly
if slides are placed on top of the guides. Inserting the slides on top of the guides could also
damage the clips that hold the mounts in place.