Nikon Multi-Power Battery Pack G02 - Manual (Page 23)

7
En
Inserting Batteries Inserting Batteries
The MB-D11 can be used with one EN-EL15 rechargeable Li-ion battery, or with six AA batteries.
Before inserting batteries, be sure that the camera is off and that the MB-D11 control lock is in the L position.
1 Turn the MB-D11 battery-chamber latch to and remove the battery holder (Figure E).
2 Ready the batteries as described below.
EN-EL15: Matching the indentations on the battery to the projections on the MS-D11EN holder, insert the battery with the arrow ( ▲) on the bat-
tery toward the battery holder power terminals (Figure F- q ). Press the battery lightly downward and slide it in the direction of the arrow until
the power terminals click into place (Figure F- w ).
AA batteries: Place six AA batteries in the MS-D11 battery holder as shown in Figure G, making sure that the batteries are in the correct orienta-
tion.
3 Insert the battery holder in the MB-D11 and latch the battery-chamber cover (Figure H). Make sure the holder is fully inserted before turning the
latch.
4 Turn the camera on and check the battery level in the control panel or viewfi nder. If the camera does not turn on, check that the battery is cor-
rectly inserted.
The EP-5B Power Connector
When using the EP-5B power connector, insert it into the MS-D11EN holder with the arrow ( ▲) on the connector toward the battery power terminals. Press
the connector lightly downward and slide it in the direction of the arrow until the power terminals click into place (Figure I- q ). Open the holder power
connector cover and pass the EP-5B power cable through the opening (Figure I- w ).