Connecting to the macintosh computer, Connecting to the ibm pc/at or compatible computer, Connecting the scanner – Nikon AX-210 User Manual
Page 30
20
Nikon
ScanTouch 210 User's Manual
4. Connecting the Scanner
Connecting to the Macintosh computer
When connecting the unit directly to your Macintosh computer, connect
the 25-pin connector to the computer, and the 50-pin connector to the
unit. If the unit is the only connected SCSI device, or if the unit is
connected at the end of the SCSI chain, attach the supplied SCSI
terminator between the 50-pin SCSI connector on the unit and the SCSI
cable, as shown below.
Connecting to the IBM PC/AT or compatible computer
When connecting the unit directly to the IBM PC/AT or compatible
computer, connect the 50-pin connector to the computer, and the 25-pin
connector to the unit. If the unit is the only connected SCSI device, or
if the unit is connected at the end of the SCSI chain, attach the supplied
SCSI terminator to the 50-pin SCSI connector on the unit, as shown
below.
Terminator
25-pin connector
50-pin
connector
Terminator
50-pin connector
25-pin
connector