Nikon LS4000 - Manual (Page 125)

115
4 Once scanning is complete, you can exit Nikon Scan and turn the scanner off.
Ejecting Film
The SA-21 is equipped with a locking mechanism that prevents the adapter from being removed
while film is in place. Before removing the SA-21 from the scanner, be sure to eject the film by
clicking the eject button in Nikon Scan (circled in the illustration above). Attempting to remove
the adapter without ejecting the film can result in the adapter becoming separated from the
connectors at the rear of the adapter slot, interfering with scanning. If you have attempted to
remove the adapter before ejecting film, push the adapter back into the slot slightly to ensure
that the connection is not interrupted. Do not attempt to remove the adapter by force, as this
could damage both the adapter and scanner.
To eject film when the computer is off or Nikon Scan is not running, turn the scanner off and then
on again. The film will be ejected automatically, releasing the adapter lock mechanism. Wait for
the status LED to stop flashing and then remove the adapter and close the sliding cover.
4-2. Remove the film adapter
Slide the film adapter from the adapter slot.
4-1. Eject the film
Click the eject button in Nikon Scan to eject
the film from the scanner.