Nikon LS4000 User Manual

Page 141

Advertising
background image

131

8

148

29

The status LED flashes

rapidly (scanner connected

to computer)

• A connection error or scanner hardware malfunction

has occurred
Turn the scanner and computer off and disconnect the scan-
ner from the computer. Wait five seconds, then turn the
scanner on again. If the status LED flashes rapidly, a hard-
ware malfunction has occurred. Contact your retailer or
Nikon service representative for advice. If the status LED
blinks slowly at first and then glows steadily, turn the scan-
ner off and reconnect it to your computer, then start your
computer and turn the scanner on. If the status LED flashes
rapidly after the scanner is reconnected and turned on, there
may be a problem with the interface between the scanner
and the computer. Try the following measures to resolve
the problem:

• Disconnect all other devices that use same interface as

the scanner

• Re-install Nikon Scan

• Update the device drivers for the USB or IEEE 1394/

Firewire interface (Windows only)

• Update the device drivers for your scanner (Windows

only)

112

6

88

The quality of scanned

images is poor

• The film is not properly inserted

Eject and re-insert film.

• The film was moved during scanning or scanner was

subjected to shock or vibration
Do not use the scanner where it will be subject to shock or
vibration. Failure to observe this precaution could result in
malfunction.

• Settings are improperly adjusted in Nikon Scan

Refer to the Nikon Scan 3 Software Manual for information
on adjusting scanner settings, or try resetting scanner set-
tings to factory defaults.

Problem

Possible Cause

Advertising
This manual is related to the following products: