Nikon LS4000 - Manual (Page 16)

En
6
Keep the Adapter Slot Closed
In order to ensure that your scanner always produces the best possible results, remove the
adapter and close the sliding cover when the scanner is not in use.
Never remove an adapter from the scanner without first ejecting the film and check-
ing that the status LED on the front of the scanner is glowing steadily. Do not insert
or remove adapters, insert or eject film, or turn the scanner off while the LED is
blinking.
After using the scanner, eject the film from the adapter and turn the scanner off,
then remove the adapter and close the sliding cover.
Choose a Location
Before connecting the power and interface cables, choose a flat, stable location for your scan-
ner close to the computer and to a suitable power outlet. Do not install your scanner where:
it would be exposed to direct or reflected sunlight
it would be subject to condensation or to drastic changes in temperature
it would be exposed to dust or smoke
it would be exposed to water vapor from a humidifier
it would be exposed to radio interference from other electronic devices
the temperature exceeds 35°C (95°F) or falls below 10°C (50°F)
other objects would block the scanner’s vents
The scanner has feet on two sides, allowing it to be installed in either of the orientations shown
below. Leave enough space around the scanner to ensure ease of operation: at least 5 cm (2˝)
above and on either side of the scanner, and 10 cm (4˝) behind it. When using the SA-21 strip-
film adapter, the front of the scanner should be at least 15 cm (6˝) from the edge of the surface
on which the scanner is placed to prevent film from falling to the floor when ejected from the
adapter’s film slot. If you are using the FH-3 film holder, leave at least 25 cm (9.8˝) free in front
of the scanner.