Nikon D300 - Manual (Page 163)

137
r
3
Select direct measurement mode.
Release the WB button briefly and then
press the button until the
L icon in
the control panel and viewfinder start
to flash. A flashing
D will also appear
in the control panel and viewfinder. At
default settings, the displays will flash
for about six seconds.
4
Measure white balance.
Before the indicators stop flashing, frame the
reference object so that it fills the viewfinder and
press the shutter-release button all the way down. The camera
will measure a value for white balance and store it in preset
d-0. No photograph will be recorded; white balance can be
measured accurately even when the camera is not in focus.
5
Check the results.
If the camera was able to measure a
value for white balance,
C will flash
in the control panel, while the
viewfinder will show a flashing
a. At
default settings, the displays will flash
for about six seconds.
Viewfinder
Control panel
Viewfinder
Control panel