Nikon D300 - Manual (Page 164)

138
r
If lighting is too dark or too bright, the
camera may be unable to measure white
balance. A flashing
b a will appear in
the control panel and viewfinder (at
default settings, the displays will flash for
about six seconds). Press the shutter-
release button halfway to return to
Step 4 and measure white balance again.
6
Select preset d-0.
If the new value for preset white balance will be used
immediately, select preset d-0 by pressing the WB button and
rotating the sub-command dial until d-0 is displayed in the
control panel.
D
Direct Measurement Mode
If no operations are performed while the displays are flashing, direct
measurement mode will end in the time selected for Custom Setting c2
([Auto meter-off delay], pg. 279). The default setting is six seconds.
A
Preset d-0
The new value for white balance will be stored in
preset d-0, automatically replacing the previous
value for this preset (no confirmation dialog will
be displayed). A thumbnail will be displayed in
the preset white balance list.
To use the new value for white balance, select preset d-0 (if no value has
been measured for white balance before d-0 is selected, white balance
will be set to a color temperature of 5,200 K, the same as [Direct sunlight]).
The new white balance value will remain in preset d-0 until white balance
is measured again. By copying preset d-0 to one of the other presets
before measuring a new value for white balance, up to five white balance
values can be stored (pg. 139).
Viewfinder
Control panel