Nikon NP64 - Manual (Page 52)

43
5. Using the Viewer (NP64/NP54)
3. Press the ◀ to select [OK] and press the ENTER
button.
The confirmation message will be displayed at the
center of the screen.
4. Press the ENTER button.
The confirmation message will be changed.
5. Remove the USB memory from the projector.
NOTE: If you remove the USB memory from the projector
without using [REMOVE USB DEVICE] from the menu, the
projector may not operate correctly. If this happens, turn off
the projector and unplug the power cable. Wait 3 minutes,
then connect the power cable, and turn on the projector.
Exiting the Viewer
1. Press the MENU button with the slide screen or
the thumbnail screen displayed.
The control bar or the pop-up menu will be dis-
played.
2. Press the MENU button again.
The on-screen menu will be displayed.
3. Select a source other than [VIEWER] and press
the ENTER button.
The Viewer will be exited.
TIP: To exit the Viewer using the remote control, select a
source other than [VIEWER].