Nikon NP64 - Manual (Page 86)

77
6. Using On-Screen Menu
➑ Menu Descriptions & Functions [RESET]
Returning to Factory Default [RESET]
The RESET feature allows you to change adjustments and settings to the factory preset for a (all) source (s) ex-
cept the following:
[CURRENT SIGNAL]
Resets the adjustments for the current signal to the factory preset levels.
The items that can be reset are: [PRESET], [CONTRAST], [BRIGHTNESS], [COLOR], [HUE], [SHARPNESS],
[ASPECT RATIO], [HORIZONTAL], [VERTICAL], [CLOCK], [PHASE], [NOISE REDUCTION], and [TELECINE].
[ALL DATA]
Reset all the adjustments and settings for all the signals to the factory preset.
All items can be reset
EXCEPT [LANGUAGE], [BACKGROUND], [SECURITY], [COMMUNICATION SPEED],
[CONTROL ID], [FAN MODE], [STANDBY MODE], [LAMP LIFE REMAINING], [LAMP HOURS USED], and
[TOTAL CARBON SAVINGS].
To reset the lamp usage time, see “Clearing Lamp Hour Meter [CLEAR LAMP HOURS]” below.
Clearing Lamp Hour Meter [CLEAR LAMP HOURS]
Resets the lamp clock back to zero. Selecting this option displays submenu for a confirmation.
NOTE: Elapsed time of the lamp use will not be affected even when [RESET] is done from the menu.
NOTE: The projector will turn off and go into standby mode when you continue to use the projector for another 100 hours after
the lamp has reached the end of its life. In this condition you cannot clear the lamp hour meter on the menu. If this happens,
press the HELP button on the remote control for 10 seconds to reset the lamp clock back to zero. Do this only after replacing the
lamp.