National Instruments NI Vision NI 17xx User Manual

National Instruments Cameras

Advertising
background image

Getting Started with the NI 17xx Smart Camera

The National Instruments 17xx Smart Camera combines an image sensor and a high-performance
processor to return either inspection results or images. While a typical industrial camera acquires and
transmits images through a standard camera bus for processing on another device, the smart camera
performs both acquisition and processing operations directly on the smart camera.

This document describes how to set up and configure the smart camera hardware, configure the
IP address, install software, and acquire an initial image.

Refer to the NI 17xx Smart Camera User Manual for information about specific features and
specifications of the smart camera. Select Start»All Programs»National Instruments»Vision»
Documentation»NI-IMAQ
to access the NI 17xx Smart Camera User Manual after configuring the
smart camera using the procedures described in this document.

Contents

Safety Information ............................................................................................................................... 1
Unpack and Verify Components.......................................................................................................... 3
Connect the Lens and Lighting ............................................................................................................ 5
Connect the Power Supply and I/O...................................................................................................... 5
Connect to the Development Computer............................................................................................... 8
Software Options ................................................................................................................................. 10
Configuring the NI Smart Camera with Vision Builder AI................................................................. 11
Configuring the NI Smart Camera with LabVIEW ............................................................................. 13
Where to Go from Here ....................................................................................................................... 15
Where to Go for Support ..................................................................................................................... 16

Safety Information

Caution

The following paragraphs contain important safety information you must follow when

installing and operating the NI smart camera.

Do not operate the device in a manner not specified in the documentation. Misuse of the device may
result in a hazard and may compromise the safety protection built into the device. If the device is
damaged, turn it off and do not use it until service-trained personnel can check its safety. If necessary,
return the device to National Instruments for repair.

Keep away from live circuits. Do not remove equipment covers or shields unless you are trained to do
so. If signal wires are connected to the device, hazardous voltages can exist even when the equipment is
turned off. To avoid a shock hazard, do not perform procedures involving cover or shield removal unless
you are qualified to do so. Disconnect all field power prior to removing covers or shields.

If the device is rated for use with hazardous voltages (>30 V

rms

, 42.4 V

pk

, or 60 V

dc

), it may require a

safety earth-ground connection wire. Refer to the device specifications for maximum voltage ratings.

Because of the danger of introducing additional hazards, do not install unauthorized parts or modify
the device. Use the device only with the chassis, modules, accessories, and cables specified in the
installation instructions. All covers and filler panels must be installed while operating the device.

Advertising