Rolls Rack Ear HR31 - Manual

HR31 RACK EAR INSTRUCTIONS
-4 -4
The HR31 rack ear kit includes:
2 - Rack ears
4 - Small flat head screws
4 - Round head screws
Pull out the silver screws on the sides of the unit. We recommend doing one side at a
time to keep the unit together and to make assembly easier. Place the rack ear on the unit
and use the round head screws to attach the ear to the unit. DO NOT TIGHTEN THE
ROUND HEAD SCREWS ALL THE WAY AT THIS POINT. LEAVE THE SCREWS BACKED
OFF SLIGHTLY UNTIL THE FRONT FLAT HEAD SCREWS ARE IN, THEN COME BACK AND
TIGHTEN THE ROUND HEAD SCREWS AFTER THE FRONT SCREWS ARE IN TO AVOID
BREAKING THE PLASTIC FRONT PANEL OF THE UNIT.
Use the flat head screws to attach the front of the
unit to the rack ears. After the flat head screws are
in go back as described above and fully tighten the
side round head screws. NOTE: YOU ARE ATTACH-
ING A METAL BRACKET TO PLASTIC. DO NOT
OVER TIGHTEN THE SCREWS AS THEY WILL
EASILY BREAK THE PLASTIC FRONT OF THE
UNIT.
Rolls Corportaion 5968 South 350 West Salt Lake City, UT 84107 www. rolls.com 12/08