RCA RCU300 - Manual (Page 3)

3
Battery Installation
and Information
Your universal remote requires two AAA Alkaline batteries
(batteries may or may not be included, depending on model).
To install the batteries:
1. Remove the battery compartment cover.
2. Insert the batteries, matching the
batteries to the (+) and (–) marks
inside the battery compartment.
3. Press and push the battery cover
back into place.
Note: Reprogramming may be
required after batteries are replaced.
Congratulations on your purchase of the 3 component
universal remote. This universal remote controls up to three
electronic components and makes juggling remote controls a
thing of the past. You can program this RCA brand universal
remote to operate most models of most brands of infrared,
remote-controlled components manufactured after 1990.
(See the enclosed Code List for a complete list of brands.)
The 3 component universal remote is easy to use, easy to
program and gives you control at the touch of your fingertips.
Note: The 3 component universal remote is already
programmed to operate most RCA, GE and PROSCAN
branded TVs, VCRs, DVD players and satellite receivers (DBS).
Just press the corresponding component key—VCR•DVD for
a VCR or DVD player; TV for a television; DBS•CABLE for a
satellite receiver or a cable box.
3 Component
Universal Remote
Key Descriptions
Indicator Light–flashes when a valid key
is pressed to indicate the remote is working.
Status of this light is important when you
are programming the remote.
Component keys (DBS•CABLE, VCR•DVD,
TV
): selects the component you want the
remote to operate.
For example, after you’ve programmed the
remote to operate your TV, you must press
the TV key first to put the remote in TV
Mode. While in TV Mode, the CHAN keys
change the channel on the TV, the VOL keys
adjust the TV’s volume, etc.
Transport keys–REW (Rewind), PLAY, FF
(Fast Forward), PAUSE, STOP: operate
the same as your original VCR or DVD
remote control, although key labels may
vary (REVERSE, FORWARD).
Backlight Key (select models only)–Turns
backlighting on/off. Backlighting will remain
on for approximately 6 seconds after last
keypress to conserve battery life.
RCU300_US_IB_REVC 7/16/03 15:17 Page 3