RocketFish RF-TRSPIPAD - Manual

QUICK SETUP GUIDE
Bluetooth Speaker
for iPad 2
RF-TRSPIPAD
Thank you for purchasing this high quality
Rocketfish product. Your Bluetooth speaker
represents the state-of-the-art in iPad®
accessories and is designed to integrate
easily into your iPad’s Smart Cover.
Charging your speakers fully for
the first time
Plug the small end of the included USB cable
into the speakers and the other end into an
available USB port on your computer. It
takes approximately four to five hours to
fully charge your speakers.
Note: You can charge your speakers and
listen to audio at the same time.
Installing the speaker unit into
the Smart Cover
Place the highlighted areas of the speaker
unit and the Smart Cover together in the
orientation illustrated in Step 1, then
proceed with the rest of the steps.
Turning on and pairing your
devices
Turn on the speakers by pushing in on the
side with the power on icon. This should
turn on the unit and automatically put it in
pairing mode. (Repeat the action on the
opposite side to pop out the other speaker
for better audio quality.)
To pair with your iPad:
From the Home screen, choose
Settings >
General > Bluetooth and turn Bluetooth on.
iPad searches for nearby Bluetooth
accessories.
Choose and Accept the Bluetooth accessory.
This device is identified as RF-TRSPIPAD.
If needed, please refer to your iPad manual
for additional pairing information.
LED is Constant Green if connection is
established with iPad 2.
Established
connection
(Green LED)
Charging in
Progress indicator
(Red blinking LED)
Full Charge indicator
(Constant green LED)
Note: Speakers will work with
most Bluetooth audio devices.
Speaker unit
Smart Cover