Roland ColorChoice Ver. 4.5 - Manual (Page 25)

Print Direction
Selects whether the print heads prints when it is moving in one direction (Unidirectional) or both
directions (Bi-directional). Unidirectional printing might produce better quality but it is slower. Some
media supports only Unidirectional printing.
Overprint
Defines the number of times to print the same image superimposed over the same position. The default
is one.
Page Spacing
You can specify the margin between pages. By specifying ‘0mm’, you can connect two or more pages.
Media Feed Calibration
Check Media Feed Calibration to print in accurate distances. Uncheck this option if you manually
calibrate, via the Setup menu in the printer panel.
Cut Media After Printing
Check “Cut Media After Printing” to separate the sheet after printing is complete.
Dry Time [CAMM JET/SOLJET SC-500 Only]
Defines the ink drying time. When performing Print and Cut, it will wait the specified amount of time
before cutting. Set longer interval when using media that does not absorb the ink well.
Print Crop Mark [CAMM JET/SOLJET SC-500 Only]
When this option is checked, the printer will add automatically a crop mark to the output. This option has
the same effect with the setting done in the printer panel (CROP MARK - ENABLE).
By adding the crop mark to the output, you can remove the print from the printer, then set it back and
perform the contour cut with correct alignment. Please consult "User's Reference - Remove the Printed
Material, then Reload the Material and Perform Cutting" in the CAMM JET/SOLJET SC-500 User's
Manual for more information.
See the procedures below to print, laminate and then cut a design file with Print and Cut data.
1. Open Job Properties and select "Print Only" for the "Send" mode in General tab.
2. Open the Print tab and click on the Driver Options button to display the Driver Options dialog.
3. Check the "Print Crop Mark" option. After these settings, the printer will only print, adding the crop
mark to the output.
4. Remove the print out from the printer and laminate it. Follow the instructions from the section "User's
Reference - Remove the Printed Material, then Reload the Material and Perform Cutting" in the
CAMM JET/SOLJET SC-500 User's Manual to reload the media in the printer, and adjust the base
point and the alignment based on the crop mark.
5. Open Job Properties and choose "Contour Only" for the "Send" mode in the General tab.
6. Open the Print tab and click on the Driver Options button to display the Driver Options dialog.
7. Uncheck the "Print Crop Mark" option. After these settings, CAMM JET/SOLJET SC-500 will only
process the contour cut.
Advance After Print [CAMM JET/SOLJET SC-500 Only]
Moves the media forward and resets the origin after the printing is completed.
Perform Color Correction
Checking this setting activates the color correction settings. If this setting is not checked, incoming jobs are
assumed to already have color corrected in the design application.
25