Roland ColorChoice Ver. 4.5 - Manual (Page 30)

Width/Height
Accepts direct entry of the job’s width or height. When one aspect is altered the other is automatically
updated to keep the job proportionally correct.
Copies
Number
You may change the number of copies of the job to be output.
Spacing
You may change the spacing between the copies that are output.
Layout
Output at Origin
Select this option to output the job at the machine’s origin on the edge of the media.
Output in Center
Select this option to output a job in the center of the media.
Output in the Center of Media
Select this option to output the job in the center of a sheet of media.
Offset W
Select this option to set an offset distance from the machine’s origin.
Offset H
Select this option to set an offset from the leading edge of the media.
Horizontal Mirror
Click to mirror the job horizontally.
Rotate
Click to rotate the job 90 degrees.
After Output
Choose what to do with the job after it is done processing, either Hold or Delete.
Send (CAMM JET/SOLJET SC-500)
If you have a device which prints and cuts, you can specify to send the print and the contour, the print only, or
the contour only.
Job Properties Print Tab
For more information on Print Tab options, refer to the Print Tab section in Setup Properties section of this
manual.
30