Roland ColorChoice Ver. 4.5 - Manual (Page 5)

Welcome
Welcome to the User Guide for the Roland ColorChoice® RIP Software. We recommend that you read and
understand this document. This document contains instructions for the Apple® Macintosh® and the
Microsoft® Windows® 95/98/ME, Windows® 2000 and Windows NT®.
System Requirements Windows
The following table lists the minimum and high volume recommended system setup to run RIP Software.
System requirements vary according to the size of the files to be scanned and printed, the output device used,
and other variables. Your particular setup and intended use of the software determine what hardware and
software setup you need to get the most out of RIP Software. If you are working with relatively small files, the
minimum setup may be sufficient. Similarly, if you are working with large files, you should consider the
recommended setup. Consult your dealer for advice when choosing a system.
Minimum Recommended
Processor Pentium® II 233MHz Pentium II 400MHz or faster
RAM 128MB 256MB or more
Install Space 200MB 200MB
Working Disk
Space
2GB 4GB or more for storage
Operating System
Running latest version of: Windows95
OSR2 / Windows 98/ ME / NT 4.0(*1) /
2000
Running latest version of: Windows98 /
ME / NT 4.0(*1) / 2000
Video
800 x 600 screen resolution with 16 bit
color 1024 x 768 screen resolution with 16 bit
color
Others
4x CD-ROM Driver 16x CD-ROM Driver
Parallel ECP Capable ECP Capable
Network (*2) 10 BASE-T 100 BASE -TX
(*1) Windows NT 4.0 requires Internet Explorer 4 or greater & Service Pack 4 or higher.
(*2) Only when printers with network capabilities are used. TCP/IP should be installed and working properly.
5