Roland ColorChoice Ver. 4.5 - Manual (Page 6)

System Requirements Macintosh
The following table lists the minimum and high volume recommended system setup to run RIP Software.
System requirements vary according to the size of the files to be printed, the output device used, and other
variables. Your particular setup and intended use of the software determine what hardware and software
setup you need to get the most out of RIP Software. If you are working with relatively small files, the minimum
setup may be sufficient. Similarly, if you are working with large files, you should consider the recommended
setup. Consult your dealer for advice when choosing a system.
Minimum Recommended
Processor Power PC 166 G3 or G4 300 MHz or faster
RAM
128 MB RAM with at least 196 MB of
virtual memory enabled 256 MB RAM with at least 257 MB of
virtual memory enabled
Install Space 200MB 200MB
Working Disk
Space
2GB or more 4GB or more for storage
Operating System
Mac OS 8.5 – 9x with Appearance
Manager and ColorSync installed Mac OS 8.5 – 9.x with Appearance
Manager and ColorSync installed
Video
800 x 600 screen resolution with 16 bit
colors 1024 x 768 screen resolution with 16 bit
colors
Others 4x CD-ROM Drive 16x CD-ROM Drive
Parallel Output MAC/PCI Card MAC/PCI Card
USB Output USB-PIA (requires Mac OS 8.5 or later) USB-PIA (requires Mac OS 8.5 or later)
Network Output (*) 10 BASE-T 100 BASE-TX
(*)Only when printers with network capabilities are used. TCP/IP should be installed and working properly.
6