Regency Wood Insert I2400 User Manual

Wood inserts, I2400 medium wood insert

Advertising
background image

189

June 2007 Regency Product Specifi cations Book

Wood Inserts

W
ood Inser

ts

I2

400 Wood Insert

Minimum Fireplace Opening

Height

21-1/2” (546mm)

Width

25” (635mm)

Depth

17” (432mm)

Faceplate Dimensions

Standard

40” (wide) x 30” (height)

Oversize

48” (wide) x 33” (height)

Dimension Description

I2400

A

Adjacent Side Wall (to side)

11” (280mm)

B

Mantle (to top)**

20” (508mm)

Mantle Depth (not shown) Maximum

20” (508mm)

C

Top Facing (to top)

12” (305mm)

D

Side Facing (to side)

8” (205mm)

E

Minimum Hearth Extension*

18” (455mm)

F

Minimum Heath Thickness*

1/2” (13mm)

G

Minimum Hearth Side Extension

8” (205mm)

Firebox height is 21” at highest point.

Side and Top facing is a maximum of 1-1/2" thick.
Floor protection must be non-combustible, insulating material with an R value of
1.1 or greater.

*

Hearth thickness of 1/2" with k value = 0.84", R value = 6 or greater.

** A non-combustible mantel may be installed at a lower height if the framing

is made of metal studs covered with a non-combustible board.

Thermal fl oor protection is not required if the unit is raised 3-1/2" minimum
(measured from the bottom of the stove). However, standard ember fl oor protection
is required. It will need to be a non-combustible material that covers 16" (406
mm) in the US and 18" (450 mm) in Canada to the front of the unit and 8" (200
mm) to the sides.

If the unit is not raised, thermal fl oor protection required is 18" (450 mm) in the
US and Canada.

All fl oor protection must be non-combustible (i.e., metals, brick, stone, mineral
fi ber boards, etc.) Any organic materials (i.e. plastics, wood paper products, etc.)
are combustible and must not be used. The fl oor protection specifi ed includes
some form of thermal designation such as R-value (thermal resistance) or k-factor
(thermal conductivity).

I2400 Medium Wood Insert

Advertising