Radio Shack Universal Remote User Manual

On off

Advertising

Your Micro RC might cause TV or radio interference even when it is operating properly. To
determine whether your Micro RC is causing the interference, turn off your Micro RC. If the
interference goes away, your Micro RC is causing it. Try to eliminate the interference by:

moving your Micro RC away from the receiver

contacting your local RadioShack store for help

If you cannot eliminate the interference, the FCC requires that you stop using your Micro RC.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

Changes or modifications to this product not expressly approved by RadioShack, or operation
of this product in any way other than as detailed by the Owner's Manual, could void your
authority to operate the product.

!
!

The FCCWantsYou to Know

Attach the WRIST STRAP as shown below to prevent dropping your
CONTROLLER. Thread the string through the hole on the left side of the
CONTROLLER as shown, and then thread the strap through the ring of
the string.

ON OFF

ON O

OFF

OPEN

O
P

Performance Gears

Performance Motors

If your micro RC does not stop moving after you release the trigger, adjust the NEUTRAL ADJUSTMENT screw
on the rear of the CONTROLLER until the wheels stop.

You can change the operation channel even during charging. The LED blinks
red until you complete the channel programming sequence. It lights GREEN
after charging has been completed successfully.

Wheel Alignment:

wheel alignment screw

Steering

Trim Adjustment

Notes

If your micro RC does not drive in a straight line when

you release the steering knob, adjust the

on the

bottom of the micro RC with the supplied screwdriver or the

located on the left panel of the CONTROLLER.

1. You can only align the wheels when both the CONTROLLER and the micro RC are

turned on.

2. If you adjust the wheel alignment screw on the bottom of your micro RC, you must

push or pull the trigger to keep the wheels turning during the alignment process.

3. To lengthen the operating time of your battery, unplug the lights CONNECTOR from

the circuit board.

4. The lights draw power away from the motor as battery power decreases. Unplugging

the lights may improve your speed under these conditions.

5.The headlights turn on in white when your micro RC moves forward. The tail lights turn on in red when it moves

backward.

6. When you’ve finished driving, slide ON/OFF on the CONTROLLER to OFF and retract the CONTROLLER’S antenna.

7. The default channel is 1. When you turn off your micro RC, it will revert to channel 1.

8. When speed or steering response from your micro RC decreases, recharge your micro RC.

Performance Adjustments

Attach the Wrist Strap

Customize your ZipZaps micro RC
with performance, body and power
upgrade kits, available at your
nearby RadioShack.

!
!
!
!
!

Keep your ZipZaps micro RC dry; if it gets wet, wipe it dry immediately.

Use and store your micro RC only in room-temperature environment.

Running your micro RC continuously for long periods can generate high heat levels.

Handle your micro RC carefully and do not drop it.

Keep your micro RC away from dust and dirt – you can wipe it with a damp cloth occasionally to
keep it looking new.

Modifying or tampering with your ZipZaps micro RC’s internal components can cause a malfunction
and might invalidate its warranty and void your FCC authorization to operate it.

If your micro RC is not performing as it should, take both the car and the CONTROLLER to your local

RadioShack store for assistance.

Zip Tips

LIMITED NINETY (90) DAY WARRANTY This product is warranted by RadioShack against manufacturing defects in material and
workmanship under normal use for ninety (90) days from the date of purchase from RadioShack company-owned stores and authorized
RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED
WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE
DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO
LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE
CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY,
INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR
PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the above limitations or exclusions may not apply to you. In the event of a product defect during the
warranty period, take the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its
option, unless otherwise provided by law: (a) correct the defect by product repair without charge for parts and labor; (b) replace the product
with one of the same or similar design; or (c) refund the purchase price. All replaced parts and products, and products on which a refund is
made, become the property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service.
Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or
replacement of the product made after the expiration of the warranty period.This warranty does not cover: (a) damage or failure caused by or
attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or
maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs other than those provided by a RadioShack
Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or
(f) costs of product removal, installation, set-up service adjustment or reinstallation.This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.

RadioShack Customer Relations, 200 Taylor Street, 6th floor, Fort worth, TX 76102

12/99

Warrranty

If your micro RC’s motor runs, but it does not respond to the CONTROLLER, move closer to
your micro RC and try again.

You cannot operate your micro RC near devices that use the same channel as your micro RC.
Check your micro RC’s CONTROLLER to see which frequency your car uses.

Turn off the controller and the RC, and then turn them on before repeating the programming
and charging.

If your micro RC moves slowly and you just charged or recharged it, check the wheel
mechanisms for lint, thread, hair, or dust.

CBs could interfere with control of your micro RC. If this happens, move it away from the CB.

ZipZaps Care

9. Should you lose steering control while driving your ZipZaps car, you can regain control by recentering

the

on your

. Once your car begins steering freely again, you can

realign the

STEERING TRIM

CONTROLLER

STEERING TRIM

100

S:\010087\010087Pub\Project\600\ZipZaps 2.0\ZipZaps2 manual.cdr
Monday, July 28, 2003 9:33:46 AM

Color profile: Generic CMYK printer profile
Composite Default screen

Advertising

Popular Brands

Popular manuals