Roland SP-555 - Manual (Page 39)

39
D Beam controller
If you press [FILTER] so the button is lit, you’ll be able to
control the cutoff frequency of a filter by moving your hand
above the controller.
[FILTER] will blink when you’re within the effective range of
the D Beam controller.
Press [FILTER] + a pad to select the desired combination of
filter type and resonance.
• Pad 1: Low-pass filter
• Pad 2: High-pass filter
• Pad 3: Band-pass filter
• Pad 4: Notch filter
Higher pads select a filter with stronger resonance.
If you press [TRIGGER] so the button is lit, you’ll be able to
play the desired pad by moving your hand above the
controller.
To specify the pad, hold down [TRIGGER] and press the
desired pad 1–16.
Be aware that if you select Trigger and then switch the pad
bank, the pad that will be triggered will not change, but the
sample that will be played will be different.
You can use [TRIGGER] + CTRL 3 knob to specify the velocity
at which the pad will play.
If you’re using Roll to play the pad, and you turn the D Beam
controller [TRIGGER] on, you’ll be able to use the D Beam
controller to control the volume of the roll.
If the SP-555 is in a state in which pressing a pad does not
play a sample (e.g., if [PATTERN SELECT] is lit or if [EFFECT
ASSIGN] is lit), you won’t be able to use the D Beam controller
to trigger pads.
Filter
Filter settings
Resonance
High
Zero
LPF HPF BPF NOTCH
Trigger
SP-555_e.book 39 ページ ２００７年６月２５日 月曜日 午前９時９分