Mac os x users, Changing the signal flow when using usb audio, Installing the driver – Roland SP-555 User Manual

Page 42: Installing sp-555 wave converter

Advertising
background image

42

Connecting the SP-555 to your computer

Installing the driver

* If the “Authentication” dialog box appears during the

installation, enter the password and click [OK].

1.

Start up your computer with all USB cables
disconnected (except for a USB keyboard and/or
mouse, if used).

2.

Navigate to the “Driver” folder on the CD-ROM, and
double-click SP555USBDriver.pkg.

3.

In some cases you may see the message “A program
must be executed by this installer package to
determine whether installation is possible. Continue?”
If so, click [Continue].

4.

The screen will indicate “Welcome to the Roland SP-
555 Driver installer.” Click [Continue].

5.

The screen will indicate “Select the installation
destination,” so click the drive in which the system is
installed, and then click [Continue].

6.

The screen will indicate “Easy installation,” so click
either [Install] or [Upgrade].

7.

The screen will indicate “When you install this
software, you’ll need to restart your computer when
the installation is completed.” Click [Continue with
installation].

8.

The screen will indicate “The software was installed
successfully,” so click [Restart] to restart your
computer.

This completes installation of the SP-555 Driver.

Installing SP-555 Wave Converter

1.

Navigate to the “Wave Converter” folder on the SP-
555 UTILITY CD-ROM, and double-click “SP-555 Wave
Converter Installer.pkg.”

2.

The installer will start up. Follow the on-screen
instructions to proceed with installing SP-555 Wave
Converter.

This completes installation of SP-555 Wave Converter.

For the default state and the overall signal flow, refer to

“Signal flow (block diagram)”

(p. 14).

If you’re using software that has a recording monitor or input
monitor function, and select “InP” as the source being output
from the SP-555 to USB, it is possible that the audio signal will
create a feedback loop. Either turn off the recording monitor
or input monitor function in your software, or select “OFF” or
“out” for the source being output from the SP-555 to USB
audio.

Mac OS X users

Changing the signal flow

when using USB audio

To do this

Operation

Remarks

Turn the USB audio
input on/off from
your computer

Hold down [CAN-
CEL] and use the
CTRL 3 knob (“oFF”
/ “on”)

Default setting is on.
This setting will re-
turn to the default
when you turn off
the power.

Apply or bypass the
effect for the USB au-
dio input from the
computer

While holding down
[EFFECT ASSIGN]
and [CANCEL],
press [MIC (or [LINE
IN])

The effect is applied
by default. This set-
ting will return to the
default when you
turn off the power.

Switch the source
that is output to USB
audio from the SP-
555

While holding down
[CANCEL], press
[LINE IN] and use
the CTRL 3 knob
(“oFF” / “InP” /
“out”)

The default setting is
out (output the same
signal as LINE
OUT). InP will output
only the LINE IN sig-
nal and MIC IN sig-
nal. This setting will
return to the default
when you turn off
the power.

SP-555_e.book 42 ページ 2007年6月25日 月曜日 午前9時9分

Advertising