REL Acoustics Strata 5 - Manual (Page 17)

REL Acoustics ST 5 User Manual
17
RUNNING IN
Care taken over running in will be rewarded by many years of pleasurable use. Both the
electronics and the drive unit will benefit from an initial period of carefully controlled use.
Possible damage may be sustained by running in the unit at too high a volume setting over an
extended period. On the other hand, by taking a little care over this initial period - about 24
hours of actual use - a longer life with a higher potential eventual performance is assured.
OVERLOAD PROTECTION
REL sub-bass systems are designed as true sub-bass generators. They are designed to
reproduce those exceptionally deep notes that are felt rather than heard. They will attempt to
do this at whatever volume level you set. If the volume is set too high, no damage should
result because the built-in electronics will limit the cone movement. This electronic control is
called Set-Safe®. It constantly and instantaneously monitors the output from the power
amplifier and is totally transparent in operation until required. This means it has absolutely no
effect on the sound quality of any REL Sub-Bass System until an overload is detected.
Ordinarily an overload would cause the power amplifier to go into clipping with resultant loss
of control over the drive unit. Apart from being sonically offensive, this can cause drive unit
damage. Set-Safe® detects the point of incipient clipping and reduces the signal level to
ensure actual clipping does not occur.
Even without Set-Safe®, overload would be a difficult thing to achieve because REL sub-bass
systems have particularly high current amplifiers and very powerful drive units specifically
designed for high sound pressure levels.
From our tests, we believe it would be very difficult to deliberately damage a REL sub-bass
system. Nevertheless, anything can be damaged if sufficient effort is made. Although
everything possible has been done to minimise damage from moderate attempts at
overloading, there can be no defence against those individuals who deliberately and
perversely abuse the device. Such damage is NOT covered by Warranty. Please remember,
a REL sub-bass system is there to supplement your main system, not to overwhelm it!
CARE AND POLISHING
Brittex (sprayed) finishes:
These are best maintained by careful dusting with a lint free cloth. Alternatively, a soft
bristled brush may be used to sweep off any dust falling on the surface. If objects are to be
placed upon the top, it is advisable to use a small mat to protect the surface and to avoid the
risk of rattles.
Wood veneer finishes:
Dusting as above, plus the occasional polishing with a good quality furniture polish for the
wood veneers. Treat the finish as you would any other piece of quality furniture in your home.