Oregon EMR201A - Manual

UNPACK
Make sure that you have all of the parts of one of the three
groups of products shown here before the installation of your
Weather Collection product.
A
SET-UP WIRELESS SENSOR
B
SET-UP MAIN UNIT
C
WEATHER
THN132N
Temperature
Sensor
1×
RAIN AND
TEMPERATURE STATION
Rain Collector
1×
Screws (Type C)
3×
Washers
6×
Filter
1×
Main Unit
1×
QUICK START GUIDE
OREGON SCIENTIFIC WEATHER COLLECTION
Slide open battery door 1 Install the battery, matching polarity (+/-) 2
Assign a channel by sliding selection switch to the appropriate
channel (1,2,3) location. If installing additional sensors, make
sure you assign a different channel for each sensor.
Press the reset button
Before placing the sensor outdoors, please verify
communication with the main unit by placing the sensor next to
the base unit during this setup process.
3
4
Atomic Clock Signal
Atomic clock synchronization will automatically occur after
installing the batteries. Reception takes 2-10 minutes. If the
signal is weak, it can take up to 24 hours to retrieve a valid
signal.
Please monitor atomic clock icon ( ) on the bottom part of the
LCD display next to the time. This icon indicates the status of
the clock reception signal.
3
WEATHER
THGR122NR
Temperature/
Humidity Sensor
1×
Main Unit
1×
Main Unit
1×
2
1
3
4
Install the required number of batteries in the battery
compartment located on the back of each main unit. 1
There are two types of signals the main unit will receive:
Temperature Signal
After installing the batteries, the main unit will automatically
search for the signal from the wireless sensor. Once a
temperature reading is displayed on the LCD screen,
communication is now established.
2
1 2
3
Time is synchronized.
Receiving signal is strong.
Time is not synchronized.
Receiving signal is weak.
: BAR206A
: BAR208HGA
RAIN AND TEMPERATURE STATION:
RGR202A
: EMR201A
: RMR202A
: RMR203HGA
You will have one of the following Oregon Scientific products:
100
200
300
500 100-400
400
500
*
*
THN132N
Temperature
Sensor
1Ч