On-Q/Legrand REV.O 1307877 User Manual
Page 17
Page 13
301 Fulling Mill Road, Suite G
©Copyright 2005 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA 17057
www.onqlegrand.com
(800)-321-2343
10. Click on the Associated Stations link (beside the SSID) to display a list of wireless devices
associated with this WAP. The list includes the wireless device MAC address and connection
status (see Figure 18).
11. The Channel field allows you to select which channel this device will use to communicate with
other wireless devices in the network. Click on the down arrow at the right of the field to see
the selections (as shown in Figure 19). The default channel is Channel #1.
NOTE: The IEEE 802.11g standard supports up to 13 channels worldwide. Each channel is
assigned a center frequency 5 MHz higher or lower than the adjacent channel. A 30 MHz
separation may be required to avoid interference between two wireless networks operating
in close proximity. Each associated wireless client must use the same channel number in
order to communicate.
12. The WAP 802.11g can have its Operation Mode set to operate in either an 802.11b client
only mode, an 802.11g client only mode, or a mixed mode as shown in Figure 20.
13. The Transmit Rate allows you to select the data transmission rate from 1 Mbps to 54 Mbps
for devices as shown in Figure 21. The default is Auto.
Figure 21
Figure 20
Figure 19
Figure 18