Onkyo TX-SR606 - Manual (Page 88)

88
Controlling Other Components —Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via
, use
the following remote control codes:
• [DVD] REMOTE MODE button
30627: Onkyo DVD player without (default)
• [CD] REMOTE MODE button
71817: Onkyo CD player without (default)
Note:
• If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE
IN/OUT jacks, or connect an RI Dock to the
GAME/TV jacks, for
to work properly, you must
set the Input Display accordingly (see page 45).
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
1 Make sure the Onkyo component is con-
nected with an
cable and an analog
audio cable (RCA).
See page 36 for details.
2 Enter the appropriate remote control code
to the REMOTE MODE button.
• [DVD] REMOTE MODE button
31612: Onkyo DVD player with
• [CD] REMOTE MODE button
71327: Onkyo CD player with
• [TAPE] REMOTE MODE button
42157: Onkyo cassette recorder with
(default)
See the previous page for how to enter remote
control codes.
3 Press the REMOTE MODE button, point
the remote controller at the AV receiver,
and operate the component.
1 While holding down the REMOTE
MODE button that you want to
reset, press and hold down the
[AUDIO] button until the Remote
indicator lights up (about 3 sec-
onds).
2 Within 30 seconds, press the
REMOTE MODE button again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
Each of the REMOTE MODE buttons
is preprogrammed with a remote con-
trol code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1 While holding down the
[RECEIVER] REMOTE MODE but-
ton, press and hold down the
[AUDIO] button until the Remote
indicator lights up (about 3 sec-
onds).
2 Within 30 seconds, press the
[RECEIVER] REMOTE MODE but-
ton again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
(3 seconds)
(3 seconds)