Oregon Scientific RMR603HGA User Manual
Page 10
EN
9
TURN ATOMIC CLOCK ON/OFF
Perform this step if you cannot receive Atomic Clock
signals. Press and hold ZONE for 2 seconds. Then,
manually set the clock following the "Set Clock"
instructions (below).
SET CLOCK
You only need to do this if you have disabled the Atomic
Clock feature (for example, if you are too far from or
cannot receive a signal).
1.
Open the battery compartment.
2.
Press ZONE repeatedly to display the desired Time
Zone: (P) Pacific, (M) Mountain, (C) Central, or
(E) Eastern.
3.
Close the battery compartment.
4.
Press and hold MODE for 2 seconds. The Clock
Area will blink.
5.
Select the hour, minute, year, month, day and
language. Press UP or DOWN to change the
setting. Press MODE to confirm.
The language options are (E) English,
(F) French, and (S) Spanish.
The signal icon indicates that the Atomic Clock
feature is ON. No icon means that it is OFF
SWITCH CLOCK DISPLAY
Press MODE to toggle between Clock with Seconds,
Clock with Weekday and Calendar.
ALARM
This product is equipped with a 2-minute crescendo alarm
and 8-minute snooze.
VIEW ALARM SETTINGS
Press ((.)) . The Alarm Time and On/Off status will show
in the Clock Area.
SET ALARM
1.
Press ((.)).
2.
Press and hold ((.)) again for 2 seconds. The Alarm
settings will blink.
3.
Select the hour and minute. Press UP or DOWN to
change settings. Press ((.)) to confirm.
NOTE
RMR603HGA lab test R2
1/17/04, 4:52 PM
9