Oceanic ATOM 2.0 - Manual

Information that follows amends that provided in the documents referenced.
 Watch Alternate Time (not Main Default Time) displays Am (or Pm) when a differential (remote) time is set and On.
 Watch Daily Alarm and Countdown Timer sound for 10 seconds, instead of 3 beeps as described.
 ALT (Alternate) Displays return to the MAIN Display after 5 seconds, instead of 3 seconds as described.
Manual page 40 & Review Card - Dive Computer Operating Mode Selection:
The manual states that Dive Computer Operating Modes are ‘accessed/selected’ by 2 second presses of the M (Mode)
button and that the Operating Mode is ‘changed’ any time it is ‘accessed’. The procedure to actually ‘change’
operation from one Mode to another has been expanded as follows.
While viewing the Surface Main screen of an Operating Mode currently ‘selected’ (NORM, GAUG, or FREE) -
>> press/hold the M button, release when the Operating Mode you wish to select appears.
While the Mode’s graphic (GAUG, FREE, or NORM) is flashing (flashing indicates that that Mode can be selected by a
less than 2 second press/release of the M button) -
>> press/release the M button to select that Mode. That Mode’s graphic will stop flashing and that will become the
‘selected’ Operating Mode.
 If M is not pressed during a period of 10 seconds while a Mode graphic is flashing, operation will revert to the
Mode previously selected, identified by the graphic (NORM, GAUG, or FREE) scrolling with the Altitude and Wet
graphics.
ADDENDUM for ATOM 2.0
OPERATING MANUAL (Doc. No. 12-2698-r01)
and REVIEW CARD (Doc. No. 12-2699-r01)
Elapsed Dive Time (EDT) has been added to the NORM No Deco Main Dive Display (Fig. 87) and GAUG Main Dive
Display (Fig. 123) which appear as follows:
Fig. 87 Fig. 123
EDT
added
EDT
added
EDT also appears on Operating Manual
Fig. 25, 28, 77, 78, 79, 81, 83, 84,
101, 102, 106, 110, and the No Deco
Main on the back of the Review Card.
(over)