3-3 using fins commands, Using fins commands – Omron CQM1H-CLK21 User Manual

Page 178

Advertising
background image

155

Starting and Stopping Data Links

Section 5-3

CVM1 and CV-series Start Bit

CQM1H-series Start Bit

5-3-2

Using the Controller Link Support Software and CX-Programmer

Data links can be started or stopped using commands on the Data Link Menu
of the Controller Link Support Software. The node for which starting and stop-
ping is being specified must participate in the data links.

Using a Programming Device Connected to PLC Node

Using a Computer Node

Data links can be started or stopped from the Controller Link Support Board
on the local node.

5-3-3

Using FINS Commands

Data links can be started and stopped by sending the RUN and STOP FINS
commands from a node on the Controller Link to a node that is in the data
links.

Issuing the FINS Command from a Computer Node

Data link Start Bit

Start: Changed from OFF to ON or set to ON
when power is turned on
Stop: Changed from ON to OFF

15 14 13 12 11 10 9

8

7

6

5

4

3

2

1

0

Word N

N: DM 2000 + 100

×

(unit number)

Data link Start Bit

Start: Changed from OFF to ON or set to ON
when power is turned on
Stop: Changed from ON to OFF

15 14 13 12 11 10 9

8

7

6

5

4

3

2

1

0

AR 07

Node in data links

Start/stop data links

Controller Link Support Software or
CX-Net (in CX-Programmer)

IBM PC/AT or
compatible

Note The Controller Link Support Software cannot be connected to a CS-series PLC.
Use the CX-Net (in CX-Programmer).

Node in data links

IBM PC/AT or
compatible

Controller Link
Support Board

Start/stop data links

Controller Link
Support Software

FINS command:
RUN/STOP

Controller Link
Support Board

IBM PC/AT or
compatible

Node in data links

Advertising
This manual is related to the following products: