Tandberg Data Internal USB version - Manual

Installation Guide
Product Registration
Register this product at
www.tandbergdata.com/register
©2007 RDX is a registered trademark of ProStor Systems, Inc.
Part No. 433822-01
Internal USB version
PIN SIGNAL PIN SIGNAL
1
VCC 2 VCC
3 USB0- 4 USB1-
5 USB0+ 6 USB1+
7 GND 8 GND
9 Key 10 USBOC
+5VDC
DATA-
DATA+
GND
Key
1
9
2
10
www.tandbergdata.com
Power USB
1 Turn off the computer
2 Mount the RDX QUIKSTOR in the
PC. The Eject/Power LED should
be on the lower right. Secure the
unit by using the four mounting
screws provided.
3 Connect the USB and power cables
to the RDX QuikStor
4 Connect the USB cable to the host
PC mother board or USB HBA.
Pin 1 location is marked on the
cable connector with a triangle ( ).
Consult your motherboard/
HBA manual for the Pin 1 location
on the mating USB connector
5 Turn on the computer
Warning:
• Connecting the USB Cable incorrectly
to the PC will result in damage.
• Verify PIN layout on the motherboard
versus cable connector PIN OUT.