Toshiba T 720 EN - Manual (Page 5)

Bef
ore Using
8 9
POWER SUPPLY CORD SELECTION
If your line voltage is 220 to 240V, use one of the following types of cable.
Plug
configuration Plug type
Australian
240V
10A
North American
240V
15A
Switzerland
240V
6A
Line voltage
EURO
UK
220 – 240V
220 – 240V
200 – 240V
200 – 240V
200 – 240V
Plug
configuration
Plug type Line voltage
Use a 5A fuse which is approved by ASTA
or BSI to BSI362.
Always replace the fuse cover after
changing the fuse.
LABEL LOCATIONS
ON/ST AN DBY IN PU T ME NU
AU TO SE T F A N TE MP LA MP ON VO L.+ VO L.- AU TO KE YS TO NE
MANUFACTURED;
SERIAL NO.
INP UT
PLA Y
1.5A 3.3
3.3A
CAUTION Label
WARNING Label
WARNING Label CAUTION Label
CAUTION Label LASER WARNING
CAUTION Label (LED)
CAUTION Label (LASER)
CAUTION Label (LASER)
Models with Document Camera
Remote Control Models with Document Camera
SERIAL NO. Label
MODEL NO. /
RATING Label
IMPORTANT PRECAUTIONS
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to
ship your LCD projector. For maximum protection, repack the set as it was originally packed
at the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm location.
When the unit is exposed to such a change in temperature, moisture may condense on the
crucial internal parts. To prevent the unit from possible damage, do not use the unit for at
least 2 hours when there is an extreme or sudden change in temperature.
Place and Manner of Installation
• Do not place in hot locations, such as near heating equipment. Doing so could cause
malfunction, and shorten the life of the LCD panel.
• Avoid locations with oil or cigarette smoke. Doing so will dirty the LCD panel and other
optical parts, shortening their lives, and darkening the screen.
• Do not use in angle of 20° or more degrees. Doing so could shorten the life of the lamp.
• If used at high altitudes, the unit could cease operation even if used within the rated
temperature range. This is because the thinner air at high altitudes decreases the internal
cooling efficiency. Therefore, please lower the ambient temperature if using at high altitudes.