Tokina APT-641 - Manual

TOKINA Co.,Ltd.
Security Products Division
120-4 NOZUTA-MACHI,MACHIDA-SHI,
TOKYO, 195-0063 JAPAN
TEL:+81-42-734-8912 FAX:+81-42-736-0143
E-mail:[email protected]
SPECIFICATION
Video Input 8 CAMERA INPUT and EACH THROUGHOUT
Video Output MAIN OUTPUT/SPOT OUTPUT
LCD Display 16 x 2 Display
Alarm Input up to 8 Inputs
Preset 64 Preset Points
OSD Display MENU and CAMERA ID (up to 10 characters)
Function Key AUTO/AUTO PAN/SWITCHER
Focus NEAR/FAR
Joystick
PAN/TILT/ZOOM Simultaneous Control
VSD-640 RS-485 Communication Interface
External Units/PC RS-232 Communication Interface
Power Source DC 12V (500mA)
Power Consumption 6W
Weight 2kg
Dimensions 345(W)x67(H)x206(D)mm
* Specifications and design subject to change without notice for improvements.
Front Panel Front Panel Controls
1. LCD DISPLAY
This presents the setting state.
2. KEYPAD BUTTON
This button is used to control PRESET and CAMERA.
3. CLEAR
This button is a STOP function button.
4. ENT
This button is a ENTER button that selects PRESET and CAMERA.
Besides this button is used the button selects cameras of external unit.
5. PRESET
This button is a PRESET button that selects preset positions.
6. CAM
This button is a CAMERA button that selects cameras and
applys switcher function.
7. REW
This button is a REWIND button for AUTO/AUTO PAN.
8. FF
This button is a FORWARD button for AUTO/AUTO PAN.
9. AUTO
This button is AUTO Sequence and SWITCHER button.
10. AUTO PAN
This button is AUTO PAN button.
11. FAR
This button is a Far button for manual focus.
Rear Panel Rear Panel Controls 12. NEAR
1. VIDEO INPUT JACKS This button is a NEAR button for manual focus.
This jack is used as video input jacks up to eight video inputs. 13. MENU
2. EACH THROUGH OUTPUT JACKS This button is a MENU button for OSD Display.
This jack is a Throughout jack of each video input. Be sure to push the button over 3 sec to operate MENU.
3. VIDEO OUTPUT JACKS 14. CAM SW/IR
This jack is used as the output of video input. This button is CAM SW button for VRX-2201 and IR button.
Outputs consists of two outputs, AUTO and SPOT output. 15. LIGHT/WDR
4. ALARM INPUT TERMINALS This button is LIGHT button for VRX-2201 and WDR button.
This terminal is used as ALARM inputs. 16. AUX
5. RS-485 TERMINAL This button is an AUX button for VRX-2201.
This terminal is used as RS-485 Communication. 17. LOCK
6. PC This button is a LOCK button for preventing the preset setting from mishandling.
This D-SUB Jack is used to control this unit by PC.(OPTION) Be sure to push the button over 3 sec to operate LOCK.
7. EXTERNAL UNITS 18. JOYSTICK
This D-SUB Jack is used to connect the external unit. This is a Joystick that manually controls PAN/TILT/ZOOM.
8. DC POWER JACK 19. POWER SWITCH
This jack is a DC Power jack, DC 12V. This switch is a POWER ON/OFF button.
APT-641 Speed dome controller