Texas Instruments TI-83 PLUS - Manual (Page 333)

TI-83 Plus Statistics 330
Using the Stat List Editor
Entering a List Name in the Stat List Editor
To enter a list name in the stat list editor, follow these steps.
1. Display the Name= prompt in the entry line in either of two ways.
•
Move the cursor onto the list name in the column where you want
to insert a list, and then press
y 6 . An unnamed column is
displayed and the remaining lists shift right one column.
•
Press } until the cursor is on the top line, and then press ~ until
you reach the unnamed column.
Note: If list names are stored to all 20 columns, you must remove a list
name to make room for an unnamed column.
The Name= prompt is displayed and alpha-lock is on.