Tyco 4100U-S1 User Manual
Tyco Safety
Advertising
Table of contents
Document Outline
- Copyrights and Trademarks
- Approvals
- Manufacture
- Product / Site
- Non-Disclosure Agreement
- End User Liability Disclaimer
- Model Number & Firmware Revision
- Document
- Amendment Log
- Cautions, Warnings, and Regulatory Information
- Table of Contents
- List of Figures
- List of Tables
- Chapter 1 Introduction to the 4100U-S1 Fire Alarm System
- Chapter 2 Installing 4100U-S1 Components
- Introduction
- Introduction to 4100U-S1 Cabinet
- Step 1. Mounting Cabinets
- Step 2. Mounting Card Bays to Cabinets
- Step 3. Configuring Cards
- Step 4. Interconnecting Modules and Bays
- Step 5. Installing Modules into Expansion Bays
- Step 6. Installing LED/Switch Modules into Expansion Bays
- 4100U Fan Control Module
- Chapter 3 Networking
- Chapter 4 The System Power Supply & Alarm Relay Card
- Chapter 5 SPS Field Wiring (4100U-S1)
- Chapter 6 Installing a 4100U IDNet Card
- Chapter 7 PC Software Connections
- Chapter 8 Installation Checklist, Commissioning & Maintenance
- Appendix A Card Address DIP Switch
- Appendix B Programming Requirements
- Appendix C Checking System Wiring
- Appendix D Earth Fault Detection
- Appendix E Related Documentation
- Appendix F Compatible Actuating Devices
- Appendix G 4100U-S1 Specifications
- Appendix H Power Supply & Battery Capacity Calculations
- Appendix I List of Drawings